To reset your IP address

we can reset our Ip address by using command prompt 

An Internet Protocol (IP) address is a numerical label that is assigned to devices participating in a computer network utilizing the Internet Protocol for communication between its nodes.[1] An IP address serves two principal functions in networking: host or network interface identification and location addressees

command line

To find out your ip address you can type ipconfig 

if your internet connection is not working or itz showing you limited area connection 

so you can use your commad ipconfig/release

ipconfig/renew

we you type release then our ip address will get flush out

when we type renew the our ip addresss will get reset 

ipconfig/release all

the renew all along dns alsoas itz use when bhanding problem comes

and some option like

/flushdns-then resolve the DNS caches

/registerdns- refreshes all DHCP leases and re-register DNS name

/DISPLAYdns-display the dns resolver caches

/SETCLASSID-display all DHCP CLASS IDs allowed for adapter

 original designers of TCP/IP defined an IP address as a 32-bit number[1] and this system, known as Internet Protocol Version 4 or IPv4, is still in use today. However, due to the enormous growth of the Internet and the resulting depletion of available addresses, a new addressing system (IPv6), using 128 bits for the address, was developed in 1995[3] and last standardized by RFC 2460 in 1998.[4] Although IP addresses are stored as binary numbers, they are usually displayed in human-readable notations, such as 208.77.188.166 (for IPv4), and 2001:db8:0:1234:0:567:1:1 (for IPv6).

The Internet Protocol also has the task of routing data packets between networks, and IP addresses specify the locations of the source and destination nodes in the topology of the routing system. For this purpose, some of the bits in an IP address are used to designate a subnetwork. The number of these bits is indicated in CIDR notation, appended to the IP address, e.g., 208.77.188.166/24.

With the development of private networks and the threat of IPv4 address exhaustion, a group of private address spaces was set aside by RFC 1918. These private addresses may be used by anyone on private networks. They are often used with network address translators to connect to the global public Internet.

The Internet Assigned Numbers Authority (IANA) manages the IP address space allocations globally. IANA works in cooperation with five Regional Internet Registries (RIRs) to allocate IP address blocks to Local Internet Registries (Internet service providers) and other entities.

IPv4 subnetting

In the early stages of development of the Internet Protocol,[1] network administrators interpreted an IP address in two parts, network number portion and host number portion. The highest order octet (most significant eight bits) in an address was designated the network number and the rest of the bits were called the rest field or host identifier and were used for host numbering within a network. This method soon proved inadequate as additional networks developed that were independent from the existing networks already designated by a network number. In 1981, the Internet addressing specification was revised with the introduction of classful network architecture.[2]

Classful network design allowed for a larger number of individual network assignments. The first three bits of the most significant octet of an IP address was defined as the class of the address. Three classes (A, B, and C) were defined for universal unicast addressing. Depending on the class derived, the network identification was based on octet boundary segments of the entire address. Each class used successively additional octets in the network identifier, thus reducing the possible number of hosts in the higher order classes (B and C). The following table gives an overview of this now obsolete system.

 usage: